Sizzix Eclips and Sure Cuts a Lot

Post about using Inkscape with cutters or plotters.
pedwards2932
Posts: 12
Joined: Tue Aug 19, 2014 8:55 pm

Sizzix Eclips and Sure Cuts a Lot

Postby pedwards2932 » Sun Oct 30, 2016 4:57 am

I am using Inkscape to trace some model airplane plans and cut out balsa with a Sizzix. It would be great if there was a simple way to make all the crossgrain cuts separate from the cuts that go with the grain. Once I have say an wing rib done in the trace it cuts out okay but there is some inaccuracy trying to make 90 degree corners. How can I make all the cross grain on a separate layer? It is easiest to draw the wing rib as one drawing but I would need to break it apart and put either end of the rib as a different layer. Thanks

Return to “Inkscape & Cutters/Plotters”